Lamps and Rabbits

FreeCAD lamp mount

I started work on a lamp mount for a work light I am putting together for Angel.

I am going to use a scissor stand for a microphone by replacing the mount for the microphone with a 3D printed part.

I will replace the microphone mount with the new mount.

Here is the sketch I made for the new part.

Here is a video of me designing the replacement part and building it in FreeCAD.

Animate with sound

I did a couple more lessons in Synfig Course I bought. This covered key frames and animating the face and adding audio. I cleaned up the rabbit and added mouths I could then change while the audio is talking. The software can output the video but not the audio. I took the rendered video and combined it in Shotcut.

 

Nuntio

I watched another lecture in Great Courses- Writing Great Fiction.