Arduinos, Bases and Sketches

Did some sketching
I spent some time burning a bootloader to an Arduino nano and then since I had two others I opened them burned them also. Things were a little easier this time since these came with the headers for the interface. I just had to solder them on.

I returned to designing a globe base bottom that will hold the Arduino and the RGB LED.

Here is what the bottom looks like. I designed it in FreeCAD. According to Cura it will take about 3hr and 15 minutes to print.

3D design for globe base bottom.

I also spent some time drawing. I figured hey it should not take long to get my graphic tablet up and running on my laptop so I could color one of the drawings. Getting the tablet to work too longer than I thought it would , as usual.

The rectangular area will hold the nano.