Following a path

The featured image today is what I did in the video.

Blender/ Udemy Course

I did some more lectures that covered creating a profile to extrude along a path.

Here is the connector partion with the addition of an edge.

Here is the hatchway I added a bottom to the hatch and then extruded a door seal around the perimeter.

This is a light panel. It is basically a smashed sphere that has been stretched out. I added the blue edge by converting a mesh to a curve and then taking a copy of the loop around the perimeter of the light and using that as the path for the curve.

Gary’s Gadgets

I did another video. I had a bit of a problem with the LED lightpad lights interacting with webcam causing severe flickering. I edited most of it out.